Item Connector Description
15 B1, B4, B2, B5, B3, B6 Memory module sockets
16 FAN4 Cooling fan connector
17 FAN3 Cooling fan connector
18 PWR_CONN_1 8-pin power connector
19 FAN2 Cooling fan connector
20 A1, A4, A2, A5, A3, A6 Memory module sockets
21 BP_SIG Backplane signal connector
22 PWR_CONN_2 24-pin power connector
23 CPU1 Processor socket 1
24 PDB_CONN Power distribution board connector
25 BATTERY Battery connector
26 CTRL_PNL_MB Control panel interface connector
27 SATA_A-D SATA connector A-D
28 SATA_E SATA connector E
29 SAS_A SAS connector A
30 FP_USB Front panel USB connector
31 IDSDM Internal Dual SD Module connector
32 SAS_B SAS connector B
Disabling A Forgotten Password
The system's software security features include a system password and a setup password. The password jumper
enables these password features or disables them and clears any password(s) currently in use.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions that came with the system.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system.
3. Remove the jumper plug from the password jumper.
4. Close the system.
The existing passwords are not disabled (erased) until the system boots with the password jumper plug removed.
However, before you assign a new system and/or setup password, you must install the jumper plug.
NOTE: If you assign a new system and/or setup password with the jumper plug still removed, the system
disables the new password(s) the next time it boots.
5. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
6. Open the system.
7. Install the jumper plug on the password jumper.
8. Close the system.
9. Assign a new system and/or setup password.
119
To Next Page
Loading...
Need help?
General