Replacing the antenna
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Adhere the antennas to the slot on the display-assembly base.
2 Replace the two screws (M2x2.5) that secure antennas to the display-assembly
base.
3 Route the antenna cables through the routing guides on the display-assembly
base.
Post-requisites
1 Replace the wireless card.
2 Replace the system-board shield.
3 Replace the back cover.
4 Replace the stand.
38
To Next Page
Loading...
General