106 Removing and Installing Parts
If you installed an add-in network adapter and want to disable the integrated network adapter:
1
Enter system setup (see "Entering System Setup" on page 168), select
Integrated NIC Controller,
and
then change the setting to
Off
.
2
Connect the network cable to the add-in network adapter connectors. Do not connect the network
cable to the integrated connector on the back panel.
If you removed an add-in network connector:
1
Enter system setup (see "Entering System Setup" on page 168), select
Integrated NIC Controller
, and
then change the setting to
On
.
2
Connect the network cable to the integrated connector on the back panel of the computer.
Drives
Your computer supports:
• Six SATA devices (hard drives or optical drives)
• Two IDE devices (two hard drives or two optical drives)
• One floppy drive
• One Media Card Reader
NOTICE: When removing and replacing drives, be sure to leave the drive data and power cables connected to the
system board.
NOTE: The 5.25-inch Media Card Reader/floppy drive carrier is not interchangeable with the hard drive carrier.
To Next Page
Need help?
General
