25
14. EXPLANATION OF INDICATOR LIGHTS
LIGHTS EXPLANATION OF INDICATOR
LIGHTS
OPERATION
All lights blink briey Turning the appliance on Self-diagnosis
Permanently alight
The machine has been turned on for the
rst time and the water circuit must be
lled
Proceed as indicated in section “3. Prima
messa in funzione dell’apparecchio”
Blinking
The machine is warming up
Wait until the ideal delivery temperature has
been reached
+
-
Permanently alight
(The indicators and show
the respective selections)
The machine is ready for delivery Set up the machine and proceed with prepa-
ration of the drink
+
-
Permanently alight
(The indicator shows the
selection in progress)
The machine is ready for delivery Set up the machine and proceed with prepa-
ration of the drink
Permanently alight
There is not enough water in the tank (A7)
or the tank is not correctly in place
Fill the tank with water, or remove the tank
and reposition it correctly
Blinking
An attempt is being made to deliver a bev-
erage, but with water tank (A7) empty
Fill the tank with water
Because the beans are too nely
ground, the coee is delivered too
slowly or not at all
Remove the lter holder (C1) and repeat
the coee-making steps, bearing in mind
the indications given in sections “4.1 Fase
1 - Macinatura (grinding)” and “4.2 Fase 2 -
Pressatura (tamping)”
The coee lter (C3) or (C4) is
obstructed
Rinse the lters under running water
The tank (A7) is not properly in place
and the relative valves are not open
Press down lightly on the tank to open the
valves
Limescale in the water circuit Descale as described in section “13.
Decalcicazione”
Permanently
alight
1 cup preparation is selected The entire preparation procedure (from
grinding to delivery) is set to make 1 cup
→
White
Blue
To Next Page
Loading...
Need help?
General
