Condition Green LED Red LED
Standby or Countdown FLASH * OFF
Power ON ON OFF
Error or Fault OFF ON
Night time (No DC) OFF OFF
Bootloader mode FLASH *
* ON 1s / OFF 1s
Table 5-1 LED indicator
Figure 5-2 Country and language settings for first startup
Figure 5-3 Home page
5.2 First startup
At first startup, users have to feed in AC power and switch on the Manual
Switch. Inverter will start up on AC power and LCD display panel will come
live. Please set Language and Country according to your region and make
sure that there is no any error, fault or warning showing on home page.
Now you can feed in DC power and wait for inverter initially self-test about
2 minutes. If there is enough power generated from PV array, inverter will
start to feen in power to grid.
First Startup(M30A/ M50A)
ENT
Are you sure to
set country :
XXX
Yes / ►No
EXIT
ENT
EXIT
Select Country,
AU/NZ
Austria
Belgium
►
Select Language,
English
Deutsch
Français
►
5.2.1. Home Page
When inverter is operating normally, the LCD will display the homepage
as shown in Figure 5-3, user can get the information about output power,
inverter status, E-today, date and time.
Pressing any key in home page can users enter the main menu. Press
ESC at main manu or wait 5 minutes without any operation, the display
will return to homepage.
21. Jun 2013 13:50
Status:
Power:
E-Today:
7935
192
W
kWh
On Grid
Today Energy
Inverter Status
Output Power
Day - Time
41
Turn on PV inverter
To Next Page
Loading...
Need help?
General
