Chapter 7 Optional AccessoriesME300
7-63
Start uploading parameters to VFDSoft.
Uploading parameter is completed.
Before using the user-defined starting screen and user-defined main screen,
you must preset the starting screen setup and the main screen setup as
user-defined.
If you do not download the user-defined screen to the KPC-CC01, the
starting screen and the main screen are blank.
16. Start Wizard (ME300 models do not support this function)
Other display
When a fault occurs, the screen display shows the fault or warning.
ocA
Oc at accel
Fault
CE01
Comm. Error 1
Warning
1. Press RESET to reset the fault code. If there is no response, contact your local distributor or return the unit to
the factory. To view the fault DC BUS voltage, output current and output voltage, press MENU and then choose
Fault Record.
2. After resetting, if the screen returns to main page and shows no fault after you press ESC, the fault is cleared.
3. When the fault or warning message appears, the LED backlight blinks until you clear the fault or warning.
Optional accessory: RJ45 Extension Lead for Digital Keypad
Part No. Description
CBC-K3FT RJ45 extension lead, 3 feet (approximately 0.9 m)
CBC-K5FT RJ45 extension lead, 5 feet (approximately 1.5 m)
CBC-K7FT RJ45 extension lead, 7 feet (approximately 2.1 m)
CBC-K10FT RJ45 extension lead, 10 feet (approximately 3 m)
CBC-K16FT RJ45 extension lead, 16 feet (approximately 4.9 m)
Note: When you need communication cables, buy non-shielded, 24 AWG, four-wire twisted pair, 100 ohms
communication cables.
To Next Page
Loading...
Need help?
General