To Next Page

To Previous Page

Chapter 12 Description of Parameter SettingsME300

12.1-13-2

03-00 Analog input selection (AVI) 1 (Frequency command)

03-28 AVI terminal input selection

0 (0

–10 V)

03-50 Analog input curve selection 1 (three-point curve of AVI)

07-06 Restart after momentary power loss

2 (Speed tracking by minimum

output frequency)

07-11 Number of times of auto-restart after fault 5 (times)

07-33 Auto-restart interval of fault 60 (s)

 Group setting 04: Pump

The following table lists the relevant pump setting application parameters.

Pr. Explanation Settings

00-11 Speed control mode 0 (VF)

00-16 Load selection 0 (Normal load)

00-20 Master frequency command source (AUTO) 2 (External analog input)

00-21 Operation command source (AUTO) 1 (External terminals)

00-23 Control of motor direction 1 (Disable reverse)

01-00 Motor 1 maximum operation frequency Default setting

01-01 Motor 1 output frequency Default setting

01-02 Motor 1 output voltage Default setting

01-03 Motor 1 mid-point frequency 1 Default setting

01-04 Motor 1 mid-point voltage 1 Default setting

01-05 Motor 1 mid-point frequency 2 Default setting

01-06 Motor 1 mid-point voltage 2 Default setting

01-07 Motor 1 minimum output frequency Default setting

01-08 Motor 1 minimum output voltage Default setting

01-10 Output frequency upper limit 50 (Hz)

01-11 Output frequency lower limit 35 (Hz)

01-12 Acceleration time 1 15 (s)

01-13 Deceleration time 1 15 (s)

01-43 V/F curve selection 2 (Second V/F curve)

07-06 Restart after momentary power loss

2 (Speed tracking by minimum

output frequency)

07-11 Number of times of auto-restart after fault 5 (times)

07-33 Auto-restart interval of fault 60 (s)

Delta VFD4A2ME43ANNAA User Manual

Questions and Answers: