Denon AVR-3310 User Manual


Getting Started Connections Settings Remote ControlMulti-zone Information Troubleshooting Specifications
ENGLISH
Selecting the Surround Mode
This is the mode for playing in stereo. The tone can be adjusted.
Sound is output from the front left and right speakers and subwoofer.
This is the mode that recreates the original sound most faithfully,
providing extremely high quality sound.
1
Playing the source (vpage 50).
2
Press DIRECT/STEREO to select the “STEREO”.
1
Playing the source (vpage 50).
2
Press PURE DIRECT.
r Stereo Playback
t Playing the Pure Direct Mode
To cancel, press PURE DIRECT again.
During playback in PURE DIRECT mode, the surround parameters
are the same as in DIRECT mode.
Video signals are only output when HDMI signals are played in the
PURE DIRECT mode.
•
•
•
NOTE
When in the PURE DIRECT mode, the GUI menu display is not
displayed and the display on the main unit is turned off.
Playback
DIRECT/STEREO
PURE DIRECT
DIRECT/STEREO
PURE DIRECT
Button located on both the main unit
and the remote control unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
Rear

Denon AVR-3310 Specifications

General

Equalizer	Yes
Product color	Black
Frequency range	10 - 100000 Hz
Total Harmonic Distortion (THD)	0.05 %
AM band range	522 - 1611 kHz
FM band range	87.5 - 108 MHz
Connectivity technology	Wired
Headphone connectivity	3.5 mm
S-Video outputs quantity	2
Digital audio optical out	1
S-Video inputs quantity	7
Digital audio optical in	3
Dimensions (WxDxH)	434 x 414 x 171 mm
HDMI ports quantity	5
Power consumption (standby)	1 W
Power consumption (typical)	780 W

Weight and Dimensions

Weight	12900 g