Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Other Operations
NOTE
Recordings you make are for your personal enjoyment and should
not be used for other purposes without permission of the copyright
holder.
Input sources for which “Delete” is selected at “Source Delete”
(vpage 40) cannot be selected.
•
•
To cancel, press <ZONE2/3 / REC SELECT>, then turn <SOURCE
SELECT> until “ZONE2 Source” is displayed.
Make a test recording before starting the actual recording.
Signals are only output to the analog REC OUT connectors when
the digital signals input to the digital input connectors (OPTICAL/
COAXIAL) are PCM (2-channel) signals.
Digital audio signals input to the HDMI connectors are not output
to the REC OUT connectors, so connect using the OPTICAL or
COAXIAL connectors.
Sources selected with the REC OUT mode are output from ZONE2
as well.
In the REC OUT mode, the remote control unit’s ZONE2 mode
buttons cannot be operated.
•
•
•
•
•
•
You can listen to one program source while recording a different
program source.
1
Press <ZONE2/3 / REC SELECT> .
“ZONE2 Source” is shown on the display.
2
Turn <SOURCE SELECT> until “RECOUT Source”
is displayed.
The “ ” indicator lights.
3
Turn <SOURCE SELECT> to choose the input source
to be recorded.
4
Play the program source.
For operating instructions, refer to the respective equipment’s
operating instructions.
To record FM or AM broadcasts, select the broadcast (vpage
52).
b
b
5
Start recording.
For operating instructions, refer to the respective equipment’s
operating instructions.
b
Recording on an External Device
(REC OUT mode)
Playback
To Next Page
Loading...
Need help?
General
Weight and Dimensions
