42
ENGLISH
2 Differences in surround mode names depending on the input signals
16
SPECIFICATIONS
2 Audio section
• Power amplifier
Rated output: Front:
125 W + 125 W (
8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05% T.H.D.
)
180 W + 180 W (
6 Ω/ohms, 1 kHz with 0.7% T.H.D.
)
Center:
125 W (
8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05% T.H.D.
)
180 W (
6 Ω/ohms, 1 kHz with 0.7% T.H.D.
)
Surround:
125 W + 125 W (
8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05% T.H.D.
)
180 W + 180 W (
6 Ω/ohms, 1 kHz with 0.7% T.H.D.
)
Surround Back:
125 W + 125 W (
8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05% T.H.D.
)
180 W + 180 W (
6 Ω/ohms, 1 kHz with 0.7% T.H.D.
)
Dynamic power: 170 W x 2 ch (8 Ω/ohms)
270 W x 2 ch (4 Ω/ohms)
350 W x 2 ch (2 Ω/ohms)
Output terminals: Front/Center/Surround Back: 6 ~ 16 Ω/ohms
Surround: A or B 6 ~ 16 Ω/ohms
A + B 8 ~ 16 Ω/ohms
• Analog
Input sensitivity / input impedance: 200 mV / 47 kΩ/kohms
Frequency response: 10 Hz ~ 100 kHz: +0, –3 dB (DIRECT mode)
S/N: 105 dB (DIRECT mode)
Distortion: 0.005% (20 Hz ~ 20 kHz) (DIRECT mode)
Rated output: 1.2 V
• Digital
D/A output: Rated output — 2 V (at 0 dB playback)
Total harmonic distortion — 0.005% (1 kHz, at 0 dB)
S/N ratio — 110 dB
Dynamic range — 108 dB
Digital input: Format — Digital audio interface
• Phono equalizer (PHONO input — REC OUT)
Input sensitivity: 2.5 mV
RIAA deviation: ±1 dB (20 Hz to 20 kHz)
Signal-to-noise ratio: 74 dB (A weighting, with 5 mV input)
Rated output / Maximum output: 150 mV / 8 V
Distortion factor: 0.03% (1 kHz, 3 V)
2 Video section
• Standard video jacks
Input / output level and impedance: 1 Vp-p, 75 Ω/ohms
Frequency response: 5 Hz ~ 10 MHz — +0, –3 dB
• S-video jacks
Input / output level and impedance: Y (brightness) signal — 1 Vp-p, 75 Ω/ohms
C (color) signal — 0.286 Vp-p, 75 Ω/ohms
Frequency response: 5 Hz ~ 10 MHz — +0, –3 dB
• Color component video terminal
Input / output level and impedance: Y (brightness) signal — 1 Vp-p, 75 Ω/ohms
P
B/CB (blue) signal — 0.7 Vp-p, 75 Ω/ohms
P
R/CR (red) signal — 0.7Vp-p, 75 Ω/ohms
Frequency response: DC ~ 50 MHz — +0, –3 dB
2 General
Power supply: AC 230 V, 50 Hz
Power consumption: 600 W
Maximum external dimensions: 434 (W) x 179 (H) x 485 (D) mm
Mass: 20.5 kg
2 Remote control unit (RC-899)
Batteries: R6P/AA Type (three batteries)
External dimensions: 61 (W) x 230 (H) x 34 (D) mm
Mass: 200 g (not including batteries)
* For purposes of improvement, specifications and design are subject to change without notice.
Input signals
PURE DIRECT, DIRECT
STEREO
HOME THX CINEMA
DTS SURROUND
DTS NEO:6
DOLBY DIGITAL
DOLBY PRO LOGIC
II
DSP SIMULATION
C
C
THX
E
DTS NEO:6
E
DOLBY
PRO LOGIC
II
C
C
C
THX
E
DTS NEO:6
E
DOLBY
PRO LOGIC
II
C
C
C
✳
THX MTRX6.1
THX5.1
✳
DTS ES MTRX
DTS SURROUND
E
E
E
C
C
C
THX5.1
✳
DTS ES MTRX
DTS 96/24
E
E
E
C
C
C
B
THX DSCRT6.1
THX MTRX5.1
B
DTS ES DSCRT6.1
DTS MTRX6.1
E
E
E
C
C
C
THX
E
DTS NEO:6
E
DOLBY
PRO LOGIC
II
C
C
C
✳
THX SURROUND EX
THX5.1
E
E
✳
6,1 SURROUND
DOLBY DIGITAL
E
C
ANALOG LINEAR PCM DTS (5.1 ch)
DTS 96/24(5.1 ch)
DTS (6.1 ch) D. D. (2 ch) D. D. (5.1 ch)
DTS DOLBY DIGITALSurround Mode
C : Selectable
✳ : The surround mode name differs depending on the “SB CH OUT” surround parameter setting.
B : The surround mode name differs depending on the input signal.
E : Not selectable
To Next Page
Loading...
Need help?
General
