17
8.4.1. Cumulative operation time display
8.4.2. Servo process display
8.4. Overview of each function
1. Operation/display
Key operations are as follows.
Laser operation time ............. In STOP mode, main unit PAUSE+FWD-SKIP+ remote controller [5]
Spindle motor operation time ..... In STOP mode, main unit PAUSE+FWD-SKIP+ remote controller [6]
To reset the timer, perform the following while displaying the time with above key operation.
Laser operation time ............. In STOP mode, main unit STOP+FWD-SKIP+ remote controller [5]
Spindle motor operation time ..... In STOP mode, main unit STOP+FWD-SKIP+ remote controller [6]
2. How to utilize
Reference information in fault diagnosis of laser or spindle motor system
Review of faulty point in repeated repair
1. Operation/display
While the player is in STOP mode, perform the specified key operation to display the servo process number on FL.
When the display does not change from the error indication, press Open/Close key to show the servo process number.
Key operation: In STOP mode, main unit PAUSE+FWD- SKIP+ remote controller [7]
To Next Page
Loading...
Need help?
General
