International EMC Standards
72
Antenna configurations
This device has been designed to operate with the antennas listed below, and having a maximum
gain of [10] dBi. Antennas not included in this list or having a gain greater than [10] dBi are strictly
prohibited for use with this device. The required antenna impedance is [50] ohms
The following antenna configurations that were tested with the Connect Wi-ME 802.11 b module.
Digi 29000095, Bobbintron SA-006-1, +2 dBi dipole antenna (NP-SMA)
PCTEL, MLPV2400NGP, 2.4 GHz, 3dBi gain, no ground place, low profile antenna
MAXRAD, MFB24010, 2.4 GHz, 10 dBi Fiberglass OMNI antenna
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for
successful communication.
To Next Page
Loading...
Need help?
General
