Getting Started
Making Connections
There are several different connection options available with the RP150. Before connecting the
RP150, make sure that the power to your amplifier and the RP150 is turned off. There is no
power switch on the RP150. To turn the RP150 on or off, connect or disconnect the included
PS0913B power supply from the Power Input jack.
Mono Operation - Amplifier
Connect your guitar to the Input of the RP150. Connect a single mono instrument cable from
the Left (Mono) output of the RP150 to the instrument input or effect return on your amplifier.
Set the Amp/Mixer switch to Amp.
Guitar Amp Input/Effect Return
Left (Mono)
Output
Input
Amp/Mixer
switch set to
Amp.
NOTE: When using a
guitar amp, it may be best to
connect the Output of the
RP150 to the effect return
of the amplifier.
Stereo Operation
For stereo operation connect the guitar to the Input of the RP150. Connect one cable to the
RP150’s Left (Mono) output, and another cable to the RP150’s Right output. Connect one cable
to the input of one amplifier, channel of a mixer, or power amp. Connect the second cable to a
second amplifier, second channel of a mixer, or power amp. If connecting to a mixing console, set
the pan controls of the mixer channels hard left and right in order to retain stereo separation. If
connecting to a mixer, set the Amp/Mixer switch to Mixer. If connecting to two amplifiers, set
the Amp/Mixer switch to Amp.
Stereo Amp Setup
Guitar Amp Input/Effect Returns
Outputs Input
Amp/Mixer
switch set to
Amp.
NOTE: When using a guitar amp,
it may be best to connect the
Output of the RP150 to the effect
return of the amplifier.
To Next Page
Loading...
Need help?
General
