Model Definitions
Each Amp and Effect model within the RP150 can be programmed to suit your personal taste
and application. Understanding how these components alter the sound, and how each parameter
alters the effect, will help you achieve the sound you are looking for. The following overview of the
RP150’s effects outlines what each effect and parameter does.
Pickup
The Pickup Simulator provides the thick tone of a humbucker pickup to a guitar with single coil
pickups, or the bright, edgy sound of a single coil pickup to a guitar with a humbucker. This gives
you the best of both worlds without having to change guitars during a performance.
Pickup Model - Knob 1 selects the Pickup model to be simulated. Values include:
(gives a single coil pickup the warm tone of a humbucker), and (gives a humbucker the
unique sound of a single coil). Press this knob to turn Pickup modeling on and off.
Preset Level - Knob 4 adjusts the volume level for each preset individually.
Wah
Wah is an effect controlled by an Expression Pedal making the guitar sound as if it’s saying “Wah.”
Wah Model - Knob 1 selects the Wah model. Values include: (DigiTech
®
Full Range
Wah sweeps the entire spectrum of audible frequencies), (Cry Wah is a traditional
sounding Wah), and (based on a Vox
®
Clyde McCoy
TM
Wah). Press this knob to turn Wah
models on and off.
Wah Minimum - Knob 2 adjusts the Wah Pedal Minimum. Ranges from (toe up) to
(toe down).
Wah Maximum - Knob 3 adjusts the Wah Pedal Maximum. Ranges from (toe up) to
(toe down).
Wah Level - Knob 4 adjusts the Wah Level. Ranges from 0dB to +12dB.
Compressor
A Compressor is used to increase sustain, tighten up guitars, and prevent the signal from clipping
the input of other effects. It sets a maximum boundary for the strength of a signal.
Comp Model - Knob 1 selects one of two Compressor models: (DigiTech
®
Compressor) or (Based on a Boss
®
CS-2 Compressor/Sustainer). Press this knob to turn
the selected Compressor models on and off.
Sustain - Knob 2 adjusts the amount of sustain. Ranges from to .
Tone/Attack - Knob 3 adjusts the tone for the DigiTech Compressor, or attack for the
Boss CS-2. Ranges from to .
Compressor Level - Knob 4 adjusts the Level from the Compressor. Ranges from to
.
Attack (X-Edit
TM
only for DigiComp) - Knob 4 adjusts the amount of time the
Compressor takes to respond to a signal that exceeds the threshold. Ranges from to .
To Next Page
Loading...
Need help?
General
