DS5_en_Chap08_info-pratiques_ed02-2015
Removing a wheel
Parking the vehicle
Immobilise the vehicle where it does not
block traffic: the ground must be level,
stable and not slippery.
Apply the parking brake unless it has
been programmed to automatic mode,
switch off the ignition and engage first
gear* to block the wheels.
Check that the braking warning lamp
and the P warning lamp in the parking
brake control lever come on.
If necessary, place a chock against
the wheel opposite the wheel to be
changed.
The occupants must get out of the
vehicle and wait where they are safe.
List of operations
F Depending on equipment, remove the protective cover from from each of bolts using the tool 3
or remove the wheel trim using tool 4.
F Fit the security socket 5 on the wheelbrace 1 to slacken the security bolt (if fitted).
F Slacken the other bolts (no more than a 1/4 turn) using the wheelbrace 1 only.
* Position P for an automatic gearbox.
Never go underneath a vehicle raised
using a jack; use an axle stand.
To Next Page
Loading...
Need help?
General
