Duplo DB-200 User Manual

~39~
4.4.5 PADDING MODE:
“PAD” is one of the DB-280 operations that apply to special binding applications such as binding without
cover sheet.
1
Press “FUNCTION” button to switch to “PAD” operation. The
“PAD” LED will be lit and display flashing "LOAD PAD" as
shown.
Note:
The “NOTCH” LED is normally OFF. But you can press
“NOTCH” button to actuate it, if desired.
2
(1) Press the “OPEN” button. Be sure to follow the label
instructions on the clamp To load the pad block to the
RIGHT of the red line, then slide the pad block to the far
LEFT of the clamps and you will see the flashing "PUSH
CLOSE" display.
Step 1:
Load book to the
RIGHT of the red line.
Step 2:
Slide the book to
The far LEFT.
(2) Then press the “CLOSE” button to clamp down the pad
block and you will see the flashing "PUSH START" display.
Note:
In case you need to adjust the pad block after you have closed
the clamps, you can press the "OPEN" button twice to release it.
The LED display will show "PUSH CLOSE". After you have
adjusted the pad block, you have to press "CLOSE" button until
the clamps close. Then you will see the flashing "PUSH
START" display again.
3
(1) Press the “START” button. The LED display of control
panel will show a “Å” sign and the clamp station will move
over the notching station and return to clamp station.

Duplo DB-200 Specifications

General

Brand	Duplo
Model	DB-200
Category	Binding Machine
Language	English