Eaton 93E UPS 15-80 kVA (380/400/415 V) Installation and Operation Manual
© Eaton Corporation plc 2015. All rights reserved. Revision: 001
Document ID: 614-01975-00
50 (133)
CAUTION
Do not tilt cabinet more than 10° from vertical.
To prevent damages, lift the cabinets only with a forklift.
NOTE: For the following steps, make sure that the forklift or pallet jack
is rated to handle the weight of the cabinet (see Table 1 for cabinet
weight).
If not already accomplished, use a forklift or pallet jack to move the
UPS cabinet to the installation area, or as close as possible, before
unloading from the pallet. Insert the forklift or pallet jack forks
between the supports on the bottom of the pallet (see Figure 7
through Figure 14 for the UPS cabinet centre of gravity
measurements).
Attach the ramp to the front of
the pallet.
To Next Page
Loading...
Need help?
General
