Eaton 9PX User Manual

Eaton 9PX Lithium-Ion User Guide P-164001006—Rev 02 35
66..44 RReeppllaacciinngg tthhee UUPPSS EEqquuiippppeedd wwiitthh aa HHoottsswwaapp MMBBPP
The HotSwap MBP module makes it
possible to service or even replace
the UPS without affecting the connected
loads (HotSwap function).
Maintenance
1. Set switch
33
to Bypass position.
The red LED on the HotSwap MBP
module goes ON, indicating that the
load is supplied directly with AC input
source power.
2. Stop the UPS by pressing the
button on the UPS control panel.
LED
31
"UPS ON - OK to switch"
goes OFF, the UPS can now be
disconnected and replaced.
Return to normal operation
1. Check that the UPS is correctly
connected to the HotSwap MBP
module.
2. Start the UPS by pressing the
button on the UPS control panel.
LED
31
"UPS ON - OK to switch" on
the HotSwap MBP module goes ON
(otherwise, there is a connection error
between the HotSwap MBP module
and the UPS).
3. Set switch
33
to Normal position.
The red LED on the HotSwap MBP
module goes OFF.
1
HotSwap MBP
LOAD
29 30 3331 34 35 36
15
28
32
6 7
5
66..55 RReeccyycclliinngg TThhee UUsseedd EEqquuiippmmeenntt
Contact your local recycling or hazardous waste center for information on proper disposal of the used
equipment.
RISK OF ELECTRIC SHOCK - Observe the warning associated with the risk of electric shock symbol.
This symbol indicates that you should not discard the UPS or the UPS batteries in the trash. This
product contains sealed, Lithium-Ion batteries and must be disposed of properly. For more information,
contact your local recycling/reuse or hazardous waste center.
This symbol indicates that you should not discard waste electrical or electronic equipment (WEEE) in
the trash. For proper disposal, contact your local recycling/reuse or hazardous waste center.
Replacing the UPS Equipped with a Hotswap MBP

Eaton 9PX Specifications

General

Brand	Eaton
Model	9PX
Category	UPS
Language	English