Eaton SPD Series User Manual

Effective December 2020
12 Eaton www.eaton.com
Eaton SPD Series for mounting external
to electrical distribution equipment
Instruction Manual IM01005031E - rev. 7
5.0 Power Xpert SPD user setup
5.1 General
The Eaton Power Xpert SPD can be monitored through the local
display or through a PC with a cat 5e cable and the PC’s web
browser. Modbus, BACnet and HTTP are initially disabled to pro-
vide cybersecurity protection. Modbus can be enabled through
the LCD module or the web UI. BACnet and HTTP can only be
enabled through the web UI. The PX SPD must be rebooted
after enabling Modbus or BACnet communications.
5.2 Setup using only the local display
Once the SPD has been powered up the device’s home screen
will appear on the local display. See below. The home screen
shows the catalog number of the device, the device’s name, the
time and the firmware revision.
Figure 20. Power Xpert home screen
Setting up the date and time
To set the current date and time, press enter to go to the main
menu.
Figure 21. Power Xpert main menu
Now scroll down the menu to settings by pressing the down
arrow button. The cursor “<” is located to the right of the menu
category selection. Position the cursor to the right of settings<
by pressing the down button twice and then press enter.
Figure 22. Move cursor to settings
Next, enter a 6-digit password by pressing the up button to the
desired first number, if you go past the number press the down
button. Then press enter to go to the next digit. Repeat the
process until all 6 digits have been entered. After all 6 digits
have been entered press enter to continue.
Figure 23. Password screen
Next, select the date and time category by pressing enter.
Figure 24. Select date and time
Next press the enter button to edit the date and time or the
back button to exit and return to the previous screen.

Eaton SPD Series Specifications

General

Brand	Eaton
Model	SPD Series
Category	Surge Protector
Language	English