Chengdu Ebyte Electronic Technology Co.,Ltd.
E18-DTU(Z27-ETH) User Manual
Copyright ©2023
，成都亿佰特电子科技有限公司
4.4.3 Quickly join a ZigBee network
（1）Connect radio 2 to the computer, open the host computer software "ZigBee3.0 host computer", select the device type, enter the IP
address, enter the port number, click Connect to Server, and you can see that the right window shows that the connection is successful.
（
2
）
Click "Start Network Configuration", the LINK light of the DTU device flashes rapidly at 10Hz, and it is necessary to ensure that the
coordinator device is also in the network configuration state (see Section 5.1). Wait for a while, the LINK light of the DTU turns to solid light
or 1Hz flashing (router mode), click "Read Parameters", you can view the network access information of the device, and the network status is
"connect". If the LINK lamp turns off and the network status is "not have", the module fails to add the network, check whether the coordinator
device is in the network configuration state and whether the distance between the coordinator device and the router/terminal device is within a
reasonable range.
To Next Page
Loading...
Need help?
General
