3156-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200L/ZT4200L-FC
7. If the deck-blade system fails to stop when the operator is off of the seat and if the cause cannot be determined
after conrming the plug and socket connection of the seat is well connected, contact your EGO customer service
center immediately.
8. Push the PTO switch downward to disengage the blade motors and adjust the steering levers from electric park
brake position to neutral position.
9. Adjust the steering levers forward or backward to drive the mower; refer to “DRIVING THE MOWER” in this manual.
10. Slowly raise yourself off of the seat. The driving system should stop.
11. If the driving system fails to stop when the operator is off of the seat and if the cause cannot be determined after
conrming the plug and socket connection of the seat is well connected, contact your EGO customer service center
immediately.
WARNING: DO NOT operate the mower until the safety interlock system has been repaired by a qualied service
technician.
MOWER ADJUSTMENT
CUTTING-DECK HEIGHT ADJUSTMENT (Fig. 15)
NOTICE: EGO electric zero turn mower’s deck is set in the highest
cutting height when it is shipped. Before using the mower, the
operator should adjust the deck height to the cutting position best
suited for the lawn.
NOTICE: To prevent scalping the lawn when encountering high spots,
the two anti-scalp wheels can be adjusted when the mower is at the
desired cutting height. Depending on your desired cutting height, you
may need to change the position of the anti-scalp wheels. please
refer to “ADJUSTING THE ANTI-SCALP WHEELS” section in this
manual.
1. Make sure that the batteries have been removed from the
mower before making any adjustments.
2. To lower the cutting height, grasp the deck-height adjustment
lever and move it inwards to disengage it from the slot. Move it downward and engage it into the slot when it arrives
at the desired cutting height.
3. To raise the cutting height, grasp the deck-height adjustment lever and move it inwards to disengage it from the
slot. Move it upward and engage it into the slot when it arrives the desired cutting height.
NOTICE: Prior to mowing, the deck should be adjusted to sufcient height to avoid stumps, rocks or other obstacles that
can damage the mower deck.
DANGER
: Never attempt to make any adjustments to the mower deck while the mower is driving or the cutting blade
is engaged. Mower blades cannot be seen and are located very close to the deck housing. Fingers and toes can be cut off
instantly.
WARNING: Hold the deck-height adjustment lever rmly when setting the deck height and only release when it
is securely engaged in the desired slot. Quickly letting go of the lever may create a pinching or pulling hazard to the
operator’s hand.
1
2
15
To Next Page
Loading...
Need help?
General
