14
Reheating
Possible actions during reheating
NOTE! The oven temperature cannot be set lower than 5°C above the set core temperature.
Press "Reheating"
The LED lights
The last set oven temperature, time or core temperature flashes
for 5 seconds.
The LED marks the previous steam level in Combi mode*
Press "Start" to select the pre-set values.
Press "Oven temperature", "Time"
or
"Meat probe"
(core temperature)
When the button's LED lights,
it is activated for setting.
The last setting flashes on the display
for 5 seconds.
Set the new value using
the "Setting knob" when
the button's LED comes on.
Select steam level *
between 1-5
When reheating is
finished:
Buzzer sounds.
LED goes out.
Reheating stops.
The time display flashes.
Press "Stop"
or
Open the door.
The buzzer stops and
the actual oven temperature
and the time setting or
the actual core temperature
are shown on the displays.
Cancel reheating:
Press "Stop"
The LED goes out.
NOTE!
Settings are NOT
cancelled when the door
is opened during reheating.
Check or change the oven temperature and time
or core temperature
Press the actual button
For 5 seconds flash
set Oven temperature
and
remaining Time
or
set Core temperature
or
set Oven temperature
If correction of "flashing" values will be done:
Set the new value using the "Setting knob"
when the button's LED is lit.
Change the steam level*:
Select a new steam level between 1-5
* Applies to Combi (Hot air/Steam), Reheating Gourmet and le Chef.
Setting new values Start Reheating finished
Press "Start"
The LED lights
The displays show
- Actual oven temperature
- Remaining cooking time
or
- actual core temperature
xx
xx
xx
xx
xx
xx
xx