8
– well lit.
For the Customer's complete information, the residual risks remaining on the machine
are indicated below: such situations are deemed improper and therefore strictly
forbidden.
Residual risk
Description of hazardous situation
Slipping or falling The operator can slip due to water or dirt on the
floor
Burns/abrasions (e.g. heating
elements)
The operator deliberately or unintentionally
touches some components inside the machine
without using protective gloves
Electrocution
Contact with live parts during maintenance
operations carried out with the electrical panel
powered
Sudden closing of the lid/door/
oven door (if present, depending
on the appliance type)
The operator for normal machine use could
suddenly and deliberately close the lid/door/oven
door (if present, depending on the appliance type)
Tipping of loads
When handling the machine or the packing
containing it, using unsuitable lifting systems or
accessories or with the unbalanced load
Mechanical safety characteristics, hazards
• The appliance does not have sharp edges or protruding parts. The guards for the
moving and live parts are fixed to the cabinet with screws, to prevent accidental access.
CAUTION
In case of a significant anomaly (e.g. short circuits, wires coming out of the
terminal block, motor breakdowns, worn electrical cable sheathing, smell of
gas indicating possible leakage, etc.) the operator must:
immediately deactivate the machine and disconnect all the supplies
(electricity, gas, water).
A.5 Transport, handling and storage
• Due to their size, the machines can be stacked on top of each other during transport,
handling and storage by complying with that specified on the slip placed on the packing.
• Do not stand under suspended loads during loading/unloading operations.
Unauthorised personnel must not enter the work area.
• The weight of the appliance alone is not sufficient to keep it steady.
• For machine lifting and anchoring, do not use movable or weak parts such as: casing,
electrical raceways, pneumatic parts, etc.
• Do not push or pull the appliance to move it, as it may tip over.
• Machine transport, handling and storage personnel must be adequately instructed and
trained regarding the use of lifting systems and personal protection equipment suitable
for the type of operation carried out (e.g. overalls, safety shoes, gloves and helmet).
• When removing the anchoring systems, make sure the stability of the machine parts
does not depend on the anchoring and, therefore, that this operation does not cause the
load to fall off the vehicle. Before unloading the machine components, make sure all the
anchoring systems are removed.
• Machine positioning, installation and disassembly must be carried out by specialised
personnel.
To Next Page
Loading...
Need help?
General
