Removing USB devices
After finishing projecting, remove the USB device from the projector's
USB(TypeA) port.
For digital cameras, hard disks, and so on, turn off the power to the
device and then remove.
Starting and Ending a Slideshow
Starting a slideshow
Procedure
A
Switch the projected image to USB.s p.22
B
Connect the USB storage device or the digital camera to the
projector.
s p.41
The Slideshow starts and displays the file list screen.
Ending a slideshow
Procedure
To end a Slideshow, remove the connected USB device from the projector.
s "Removing USB devices" p.42
q
• You can insert a memory card into a USB card reader and
connect it to the projector. However, it may not be possible to
use some commercially available USB card readers with the
projector.
• If the following screen (Select drive screen) appears, select the
drive you want to use by pressing the [
][ ] buttons on the
remote control, then press the Enter button.
• To display the Select drive screen, set the cursor to Select drive
on the top of the file list screen and press the Enter button.
• Up to four drives can be recognized at one time by the projector.
Slideshow Basic Operations
This section explains the procedure for playing back and projecting
images in Slideshow.
Although the following steps are explained based on the Remote
Control, you can perform the same operations from the projector's
Control panel.
Procedure
A
Press the [ ][ ][ ][ ] buttons to set the cursor
on the file or folder you want to operate.
Making a Presentation with a Slideshow (EB-W8/X8 only)
42
To Next Page
Loading...
Need help?
General
