m
o
Indicator is lit or flashing orange
: Lit : Flashing : Off : Varies according to the projector status
Status Cause Remedy or Status
High Temp Warning (This is not an abnormality. However, if the temperature rises too high again, projection stops automatically.)
• Check that the air filter and Air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s p.72, p.77
Replace Lamp Replace it with a new Lamp.s p.74
If you continue to use the Lamp after the replacement period has passed, the possibility that the lamp may explode increases.
Replace it with a new Lamp as soon as possible.
q
• If the projector is not operating properly, even though the indicators are all showing normal, refer to "When the Indicators Provide No Help" p.62.
• If the error is not indicated in this table, stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or
the nearest address provided in the Support and Service Guide.s Epson Projector Contact List
Problem Solving
61
To Next Page
Loading...
Need help?
General
