Useful Functions
42
Enjoying 3D Images
Preparing to View 3D Images
To view 3D images, be sure to prepare a pair of commercially available 3D Glasses (with an active shutter
system that supports radio waves (RF/Bluetooth) communication system) in advance.
Check the following before viewing 3D images.
•
When the source is HDMI1 or HDMI2.
•
Set 3D Display to Auto or 3D.
When this is set to 2D, change to Auto or 3D.
s Signal - 3D Setup - 3D Display p.60
•
Pair 3D Glasses.
This projector supports the following 3D formats.
•
Frame Packing
•
Side by Side
•
Top and Bottom
If the 3D image cannot be viewed
The projector automatically projects a 3D image when detecting a 3D format.
Some 3D TV broadcasts may not contain 3D format signals. If this happens, follow the steps below to set the
3D format.
a
Press the button to display
menus in the order Signal - 3D Setup.
b
Set 3D Display to 3D.
c
Press the button to set the 3D
format on the AV device.
c
•
If you are using a device or cable that does not support 3D images, 3D projection cannot be performed.
•
For details on 3D format settings on the AV device, see the documentation supplied with the AV device.
•
When the 3D format has not been correctly set up, an image will not be correctly projected as shown
below.
•
If a 3D image is not projected correctly even when a 3D format is set, the synchronization timing for
the 3D Glasses may be inversed. Inverse the synchronization timing using Inverse 3D Glasses.
s Signal - 3D Setup - Inverse 3D Glasses p.60
•
How a 3D image is perceived varies depending on the individual.
•
When you start projecting a 3D image, a warning about viewing 3D images is displayed. You can turn
off this warning by setting 3D Viewing Notice to Off.
s Signal - 3D Setup - 3D Viewing Notice p.60
•
During 3D projection, the following Configuration menu functions cannot be changed.
Aspect (fixed to Normal), Noise Reduction (fixed to Off), Overscan (fixed to Off), 4K Enhancement,
Super-resolution, Image Processing, Picture in Picture
•
How the 3D image is viewed may change depending on the temperature of the surroundings and how
long the lamp has been used. Refrain from using the projector if the image is not projected normally.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
