INSTRUCTION MANUAL FOR INSTALLATION, MAINTENANCE AND
USE Rev−12
PMKIE−DIMU−GB−12
13
GB
INDIRECT TILTING PANS, ELECTRIC TYPE
ˆPMKIE100˜ ˆPMKIE150˜ ˆPMKIE200˜ ˆPMKIE300˜ ˆPMKIE500˜
3.3 COMMISSIONING AND TESTING
− Once all the connections have been made, the appliance and the overall installation must be checked
following the directions given in this manual.
− Check in particular:
− that the protective film has been removed from the external surfaces;
− that the lower front panel removed for the electrical connection of the appliance has been fitted back into
position;
− that connections have been made in accordance with the requirements and directions indicated in this
manual;
− that all safety requirements in current standards, statutory regulations and directives have been met;
− that the water connections are leak-free;
− that the electrical connection has been performed according to standards.
− In addition, check that once the appliance has been installed, the power cord is neither subject to stretch
nor in contact with nor surfaces.
− Now proceed to light the appliance as directed in the instructions for use.
− While the appliance is in use, voltage should not differ from the nominal voltage more than +/- 10%.
− The test report must be completed in full and submitted to the customer who should then sign in
acceptance. With effect from this moment, the appliance is covered by the manufacturer’s warranty.
3.4 MAINTENANCE OF THE APPLIANCE
All maintenance operations shall only be performed by a technically qualified service
centre!
− To ensure correct and safe operation, the appliance must be inspected and serviced at least once a year
only. Maintenance includes also controlling the components and tear of pipes, feeding pipes, electrical
components etc.
− It is advisable to replace worn components during maintenance operations to avoid the need for other
maintenance calls and unexpected failures.
− It is also advisable to apply for a maintenance contract with the customer.
3.5 PERIODIC MAINTENANCE
Periodic inspection will minimize equipment down time and increase the efficiency of operation.
The following points should be checked:
To Next Page
Loading...
General