Reservation Mode Settings
Reservation mode settings can be programmed by your authorized Firstech dealer.
Option 1: Locks doors before Reservation Mode is set.
Option 2: Hold Key/Start button to initiate Reservation Mode.
Option 3: Reservation mode sets 10 seconds after the last door is closed, as opposed to immediately.
This option will allow you to access the vehicle’s rear doors, trunk or hatch prior to the system setting
reservation and passively locking/arming.
Option 4: Locks doors after Reservation Mode is set.
Trunk Release
Hold the Trunk button for 2.5 seconds to release the trunk or hatch. If you are in
range, the remote will beep twice, trunk icon illuminate and “Trunk Open” will scroll across
the screen indicating that the trunk release command has been successfully transmitted.
IMPORTANT: Trunk release is an optional vehicle feature that may require additional parts and labor.
Auxiliary Outputs/Window Roll-Down/Sliding Doors
Your system is equipped with two additional outputs that can be configured to control windows, open
power sliding doors, open a power sliding moon roof, or even turn on a rear defroster. These outputs can
be configured for different times. Your authorized Firstech dealer can set these outputs up accordingly.
Auxiliary controlled features will require additional parts and labor.
Tap the Function button for a half second followed by the Trunk button to trigger
auxiliary output 1. Tap the Function button for a half second followed by the Key/Start
button to trigger auxiliary output 2. The remote will beep once, parking lights flash, and “AUX 1
or AUX 2” will scroll across the screen, indicating that the auxiliary output(s) have been triggered.
By default, the system is in secure auxiliary mode, which requires you to tap the Key/Start button
for a half second prior to triggering auxiliary 1 or 2. To turn off secure auxiliary, ask your authorized
Firstech dealer to turn on Option 4-5 to setting II.
Temperature and Battery Query
When in range of your vehicle, the remote will display the vehicle’s temperature and battery
voltage upon tapping the Key/Start button . The temperature will be displayed after tapping
the Key/Start button for a half second. Tap the Key/Start button a second time within
four seconds to display the vehicle’s battery voltage.
If you tap the Key/Start button and you do not get any response from the remote, the remote pager
is most likely out of range to receive commands. If you tap Key/Start button and the remote reads
“FAIL” then your temperature sensor is not installed or may be malfunctioning.
Silent Arm/Disarm
Upon lock/arm and unlock/disarm, you can eliminate vehicle’s audible confirmation by muting
the siren. Normally, the siren will chirp once to indicate the system is locked/armed and twice to
indicate the system is unlocked/disarmed. To mute the siren tap the Lock and Unlock
buttons simultaneously for a half second. When the siren is muted, the siren icon will no longer be
displayed on the LCD. IMPORTANT: Your system must be programmed by your installer before this is
available. Even when the siren is muted, it will still go off in the event the alarm is triggered.
To Next Page
Loading...
Need help?
General
