Advanced Features
The following section reviews advanced system functions. Many of these functions require multiple steps
or additional programming by your local authorized Firstech dealer to be active.
Drive Lock/Ignition Controlled Door Locks
Tap the Function button once followed by the Lock button to turn the Drive Lock on
and off. (also known as ignition controlled door locks) The remote will beep once, “Drive Lock
On” will scroll across the screen, and the icon will illuminate to confirm that drive lock mode is
activated. The remote will beep twice, “Drive Lock Off” will scroll across the screen, and the drive lock
icon will disappear to confirm drive lock is off.
IMPORTANT: Drive lock mode requires additional work from your authorized Firstech dealer. Drive lock
has two settings;
Default 1: Off
Option 2: Locks the doors when the ignition is on and after the brake is depressed.
Option 3: locks the doors when the RPM’s have reached two times that of idle speed (this setting
requires that a tachometer wire is connected).
With both settings, the doors will unlock when the ignition is turned off. If using this feature on a manual
transmission vehicle, the doors will unlock upon setting the emergency / parking brake.
Turbo Timer Mode
The built in turbo timer keeps the vehicle’s engine running for either 1, 2, or 4 minutes
(programmable from dealer) after the vehicle key has been removed from the ignition. This
feature will keep oil running through the turbo system to allow for appropriate cooling time.
Tap the Function button once followed by the Unlock button to turn turbo mode on or off. The
remote will beep once, “Turbo On” will scroll across the screen, and the turbo icon inside the motor icon
will illuminate to confirm that turbo mode is activated. Repeat to turn turbo timer off. The remote will beep
twice, “Turbo Off” will scroll across the screen, and icon will disappear to confirm turbo mode is off.
IMPORTANT: To utilize this feature, the emergency / parking brake wire must be connected to the
Firstech system. Consult your local authorized dealer for installation.
2
nd
Car Mode (Multiple Vehicle Control)
Most 2 Way remotes have the ability to operate a 2
nd
vehicle. Tap the Function button
twice then tap the Lock button to activate this feature. The remote will beep once, “2
ND
On”
will scroll across the screen, and the 2
nd
car icon will illuminate to confirm that 2
nd
car mode is activated.
The remote will beep twice, “2
nd
Off” will scroll across the screen, and the icon will disappear to confirm
2
nd
car mode is off.
IMPORTANT: 2
nd
car mode requires the remote to be programmed to a 2
nd
vehicle that is equipped with
the same system.
RPS Touch and RPS (Remote Paging Sensor)
The RPS is an optional feature. The car call/RPS feature uses a small sensor that is mounted
To Next Page
Loading...
Need help?
General
