STEP 2 : Scroll through the remote options by taping the Function button . Once the LCD reads
“RPS-ON” tap the Lock button to turn this feature on. The LCD will read “RPS-OFF”
STEP 3: Exit remote programming by holding down the Trunk and Key/Start buttons simultaneously
for 2.5 seconds. The remote will beep indicating that you have successfully exited programming. The
vibration icon will remain illuminated on the LCD indicating the remote is in remote mute/vibration mode.
RPS (Remote Paging Sensor) Unlock/Disarm
RPS and car call functions do not require programming, however in order to unlock/disarm your vehicle
you must program a 4 digit passcode using the instructions below:
STEP 1: Disarm/unlock the alarm (remote must be programmed first) and choose a 4 digit code. You can
not have zeros.
STEP 2: Turn ignition key to the “on” position and leave the driver’s door open.
STEP 3: Knock on the windshield in front of the RPS a total of 5 times (each time you knock the LED on
the RPS will flash RED). The LED will begin to flash rapidly in BLUE with successful completion of this
step.
STEP 4: Enter the first digit of the desired four digit pass code by knocking on the windshield in front of
the RPS the desired number of times. For example, to enter 3, knock on the sensor 3 times (each time
you knock the LED will flash RED) then wait.
STEP 5: The LED on the RPS will confirm your first number by flashing BLUE slowly. Once the LED
begins to flash rapidly in BLUE, enter your second number by repeating step 4.
STEP 6: Repeat steps 4 & 5 to enter all four numbers.
STEP 7: Turn the ignition OFF - the RPS disarm/unlock passcode is now programmed. Follow steps 3 –
5 to enter your disarm/unlock code.
Alarm rearm and lock
To rearm, knock on your sensor 5 times.
Alarm disarm and unlock
To disarm, knock on your sensor 5 times. Wait for the Blue LEDs to flash rapidly. Follow STEP 4 and 5
above to enter your 4 digit passcode.
2 Way LCD remote paging
To page a 2 Way LCD remote just knock on the RPS twice.
Knock Panel Sensitivity
To change knock sensitivity, disarm the system and adjust the switch on the rear of the RPS. The larger
the circle, the more sensitive the knock sensor is.
Timer Start Mode
Timer start mode is used to cool or warm the vehicle automatically without use of the key or
the remote. While engaged, timer start will activate even while the remote is out of range.
Tap the Function button twice followed by the Unlock button to activate timer start mode. The
To Next Page
Loading...
Need help?
General
