Pairing Bluetooth devices
11
11.1 General
You can use Bluetooth-enabled headsets and FLIR meters together with the camera. Be-
fore you can use the device with the camera, you need to pair the camera and the device.
11.2 Procedure
Follow this procedure:
1. Enable Bluetooth on the device. See the user documentation for that device for infor-
mation on how to do this.
2. On the camera, push the navigation pad to display the menu system.
3. Use the navigation pad to go to Settings.
4. Push the navigation pad.
5. Select Device settings and push the navigation pad.
6. Select Bluetooth including METERLiNK and push the navigation pad.
7. Enable Bluetooth by pushing the navigation pad.
8. Select Scan for Bluetooth devices and push the navigation pad right.
9. When the device is displayed in the list of devices, select it and push the navigation
pad to pair the camera and the device.
Note
• Only METERLiNK devices and Bluetooth-enabled headsets will appear in the list of
available devices.
• You can add several devices.
• You can remove a device by selecting the device and then selecting Unpair device.
• After adding a METERLiNK device, such as the FLIR MR77 or FLIR CM78, the result
from the meter will be visible in the measurement result table.
• After adding a Bluetooth-enabled headset, it is ready to be used for adding voice
annotations.
#T559845; r. AJ/37554/37554; en-US
23
To Next Page
Loading...
Need help?
General
