Job Assembly
145
Copy
3
îš„1 Sided Side 2 Only
The first page of the loaded documents is copied on the back side of a separator, and
the rest of the pages are copied on the paper other than the separator.
When [Pages per Side] is set, the number of pages (2 pages, 4 pages, 8 pages) that
you selected to copy onto one side of a single sheet, starting from the first page of the
loaded documents, are copied onto the back side of a separator.
When you load a single sheet document, the document is copied onto a separator.
îš„2 Sided Separators
The first two pages of the loaded documents are copied onto each side of a separator,
and the rest of the pages starting from the third page are copied onto the paper other
than the separator.
When [Pages per Side] is set, the number of pages (2 pages, 4 pages, 8 pages) that
you selected to copy onto one side of a single sheet, starting from the first page of the
loaded documents, are copied onto each side of a separator.
When you load two-sheet documents, both sheets are copied onto each side of a
separator.
Note • When you have two separate documents, a single sheet document and multiple sheet
documents, if you want to copy this single sheet document and the first page of the multiple
sheet documents onto each side of a separator, when loading the multiple sheet documents,
select [No Separator] in [Build Job - Separators]. If you do not select [No Separator], the
machine processes these two documents separately under different separator settings, the
single-sheet document is copied onto a separator, and the first page (or first two pages) of
the multiple sheet documents is copied onto another separator.
îš„Segment Separator Tray
Allows you to select the tray, which is loaded with paper to be used as a separator.
When [Bypass] is selected, the [Tray 5] screen is displayed. For more information, refer to "[Tray 5]
Screen" (P.90).
îš„Separator Quantity
This option is available when you select [Blank Separators]. You can specify the
number of separators in the range from 1 to 99.
Sample Job (Checking the Finished Output of the Copy)
When making multiple sets of copies, you can print a sample set to check the finished
output and then print the remaining copy sets. You can select whether to continue or
cancel the job after the confirmation. This feature also allows you to change the number
of copy sets. The sample copy is included in the total number of copy sets.
Note • After a sample set is output, the machine automatically outputs the remaining data if the
machine is left uninstructed for the period specified in [Auto Job Release]. For more
information on [Auto Job Release], refer to "5 Tools" > "Common Service Settings" >
"Machine Clock/Timers" > "Auto Job Release" in the Administrator Guide.
1 Select [Sample Job].
To Next Page
Loading...
Need help?
General
