Fuji Xerox docucentre-iv C4470 User Manual

Fax/Internet Fax
201
Fax
4
z
When using wildcards for the last two digits
When you specify address numbers, confirm that the corresponding fax numbers are correctly registered
on the machine. For information on how to register address numbers, refer to "5 Tools" > "Setup" >
"Add Address Book Entry" in the Administrator Guide.
Note • The maximum number of recipients that you can specify at one time is as follows:
Using address numbers only: 600 locations. Using the numeric keypad in combination with
address numbers: 600 locations.
• An address number is always displayed in four digits. If [Auto Validation of Speed Dial Entry]
is set to [Validate entry after a fixed time] in the System Administration mode, and for
example when you enter "**", "0" is automatically added to the beginning of the wildcards to
display "00**". For more information, refer to "5 Tools" > "Common Service Settings" >
"Other Settings" > "Auto Validation of Speed Dial Entry" in the Administrator Guide.
• You can use wildcards only for the last digit or last two digits of address numbers. The
following is not available: "*100", "**10", and "1*00"
1 Press the <Speed Dial> button, and enter a
4-digit address number. Repeat this step for
each additional recipient.
Specifying a Destination Using a One Touch Button
You can use the one touch buttons to specify recipients.
One touch buttons correspond to the address numbers from 0001 to 0070, or 0001 to
0060.
For example, when the number you want to dial is registered to the address number
0001, press one touch button <1>.
For information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book
Entry" in the Administrator Guide.
Note • There are two ways in which address numbers and stored programs are assigned to the one
touch buttons. Select either of the following. By default, [Type 1] is selected.
• [Type 1]
The buttons 1 to 70 are used for address numbers and they correspond to the registered
address numbers 0001 to 0070, while the buttons 71 and 72 are used for stored programs
and they correspond to the registered stored programs 1 and 2.
• [Type 2]
The buttons 1 to 60 are used for address numbers and they correspond to the registered
address numbers 0001 to 0060, while the buttons 61 to 72 are used for stored programs
and they correspond to the registered stored programs 1 to 12.
• The Large Size UI (optional) does not support the one touch buttons.
How to Enter Wildcard
Target Address
Numbers
The Number of Target
Addresses
00** 0001 - 0099 99
01** 0100 - 0199 100
10** 1000 - 1099 100
<Speed Dial> button

Fuji Xerox docucentre-iv C4470 Specifications

General

Brand	Fuji Xerox
Model	docucentre-iv C4470
Category	All in One Printer
Language	English