Connectivity & Network Setup
201
Tools
5
WebDAV
îš„ Port Status
Select [Enabled] when you use an application program such as EasyOperator and Network
Scanner Utility3 to access folders in the machine.
Note • You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the machine,
and then configure [Port Number] and [Operation Time-Out].
îš„ Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important •Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
îš„ Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
îš„ Port Status
You can use the machine for print in the ThinPrint environment. The machine decompresses
and prints the compressed print data sent from the server.
Select [Enabled] when you use ThinPrint.
îš„ Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important •Do not use any number s assigned to the other ports.
Note • ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.
Protocol Settings
Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Ethernet Rated Speed
Set the communication speed for the Ethernet interface.
îš„ Auto
Select this to detect the Ethernet transmission rate up to 1 Gbps automatically.
îš„ 100 Mbps Full-Duplex
Select this to set 100BASE-TX (Full Duplex) as the default value.
îš„ 100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.
To Next Page
Loading...
Need help?
General
