Replacing Consumables
83
Maintenance
3
4 Insert the emptied hole punch waste container
into the finisher until it stops.
5 Close the front transport cover, and then close the top transport cover of the finisher.
Note • If the cover is not completely closed, a message will appear and the machine remain paused.
Emptying the Hole Punch Waste Container (for Finisher-C1 or Finisher-C1
with Booklet Maker)
When the optional Finisher-C1 or the optional Finisher-C1 with Booklet Maker is installed
and the hole punch waste container becomes full, a message appears on the touch screen.
When the message appears, empty the hole punch waste container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container. Not
doing so will cause the container to fill up before the message telling you to empty the
container appears again, and this can cause machine malfunction.
Important •Empty the hole punch waste container when the machine is on. If you empty the container while the
machine is off, the machine does not recognize that the container has been emptied.
1 Make sure that the machine is not operating,
and open the finisher front cover.
2 Pull out the hole punch waste container R4.
3 Empty the container.
To Next Page
Loading...
Need help?
General
