A26391-K147-Z120-1-7619 57
Memory expansion
Depending on the upgrade level, your notebook is equipped with a 128MB, 256MB or 512MB
memory module.
!
The notebook must be switched off when installing/removing the memory modules, it
must not be in Suspend mode.
Use only memory expansions which have been released for your notebook (128, 256, or
512 Mbyte modules, PC 266 DDR SO DIMM, 200 pin JEDEC).
Never use force when installing or removing memory modules.
Make sure that foreign objects do not fall into the memory module compartment.
Installing/removing memory
During installation, note that the first slot is assigned at the factory and is therefore not available.
The second slot is free and can be used for upgrading.
► Switch the notebook off.
► Close the LCD screen so that it locks into place.
► Unplug the power adapter from the mains outlet.
► Disconnect all cables connected to the notebook.
► Turn the notebook over.
► Place the notebook on a flat surface.
► Remove the battery (see "Removing battery").
Removing cover
1
► Remove the screw (1).
► Open the cover.
► Pull off the cover.
To Next Page
Loading...
Need help?
General