Troubleshooting and tips
54 A26391-K147-Z120-1-7619
Error messages on the screen
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
Setup Warning Invalid Password <Continue>
This message is displayed following password entry.
► Press the key combination Fn + PadLK .
► Re-enter the password once.
If the problem persists, contact your sales office or our hotline/help desk.
CMOS Battery Bad
If the error message occurs repeatedly, then the buffer battery in the notebook is flat.
► Connect the notebook via its power adapter to the mains outlet. The buffer battery will take
approximately two days to complete its recharge.
If the error message appears repeatedly, please contact the place of purchase or our
hotline/help desk.
System CMOS checksum bad - Default configuration used
The system configuration information is incorrect.
► Switch the notebook off.
► Switch the notebook on.
► Enter the BIOS Setup programme by pressing F2 .
► Select the Exit menu in the BIOS Setup.
► Select the Default Setup entry and click on OK.
If the error message appears repeatedly, please contact the place of purchase or our
hotline/help desk.
Insert system diskette and press Enter key to reboot
The operating system cannot be loaded or the hard disk contains no operating system or is not
formatted.
► Insert a system disk.
► Press any key to continue.
Invalid system disk - Replace the disk, and then press any key
The inserted disk is not a system disk or the inserted system disk is defective.
► Insert another system disk.
► Press any key to continue.
If you wish to boot from floppy disk:
► Insert a system disk.
► Press any key to continue.
If the operating system cannot be loaded from floppy disk:
► Remove the floppy disk from the drive.
To Next Page
Loading...
Need help?
General