Important notes
Important notes
ImportantnotesNotes
In this chapter you will find information regarding safety which it is essential to
take note of when working with your device .
Safety instructions
This device complies wit
h the relevant safety regulations for data processing equipment,
including electronic of
fice machines for use in an office environment. If you have
any questions about whe
ther the device can be used in the intended environment,
please conta ct your sa l
es office o r our Service Desk.
• The display surface of
the device is sensitive to pressure and scratches. You should therefore
be careful with the dis
play surface in order to avoid lasting damage (scratches).
• If the device is brought into the i nstallation site from a cold environment, condensation
can form . Before op erating the device, wait until it is absolutely dry and has reached
approximately the same temperature as the installation site.
• When installing an
d operating the device , please obse rve the notes on environmental
conditions in Chap
ter "
Technical specification", Page 32 as well as the instructions in
Chapter "
Setting
up an ergonomic vi deo workstation", Page 11.
• To ensure sufficient ventilation, the air inlet and outlet openings of the device must be k ept clear.
• The d evice autom
atically sets itself to the correct voltage within the range from 100 V to 240 V.
Make sure that t
he local mains voltage is neither higher nor lower than this range.
• Ensure that the power socket on the device and the mains outlet are freely accessible.
• The ON/OFF swi
tch does not disconnect the monitor from the mains voltage. To disconnect
fully fro m the
mains supply, disconnect the powe r plug f rom the socket.
• The device is equipped with a power cable that complies with safety standards.
• Use the suppl
ied power cable only.
• Lay the cables in such a way that they do not create a hazard (danger of tripping)
and cannot be damaged. W hen connecting the device, observe the relevant
notes in chap ter "
Connecting the device", Page 15.
• No data tra
nsfer cables should be connected or disconnected during a thunderstorm.
• Make sure that no objects (e.g. j ewe llery chains, paper clips, etc.) or liquids get
inside the device (danger of electric shock, short circuit).
• The devic
e is not waterproof! Never immerse the device in wate r and protect
it from s
pray water ( rain, sea water).
• In an emergency (e.g. d amaged casing, operation controls or cables, penetration
of liquids or foreign matter), switch off the device, disconnect the power plug
and contact y our sales outlet or our Service Desk.
• Repai
rs to the de vice must only be performed by qualifie d te chnician s. Unauthorised opening
and in
correct repair may gre atly endanger the user (electric shock, fire risk).
• Only use the screen resolution settings and refresh rates specified in Chapter
"
Technical specification", Page 32. Otherwise you may damage the device. If you
are in any doubt, contact your sales outlet or our Help Desk.
•Usea
screen saver with moving images and activate the power management for
you
r monitor to prevent still images from "burning in".
• If you operate the device with the swivel arm or wall bracket, it must not be turned by 180°.
Fujitsu Technology Solutions 7
To Next Page
Loading...
Need help?
General