Fujitsu Stylistic User Manual

28
* Information in Table 2-1 is supplied to help you understand which system states your system
can enter from the current system state. Refer to the procedures on starting the system, shutting
down the system, suspending system operation, and resuming system operation given later in
this chapter.
❖ Your system may be configured to use either Suspend-to-RAM mode or Hibernate mode.
POWERING UP THE TABLET PC
Follow the procedure below to start the
Stylistic Tablet PC. Before you begin, confirm
that the system is in the Off state. To do so,
observe the Status display. If the Power icon is
not visible in the Status display, the system is
in Off state or in Hibernate (Save-to-Disk)
mode and it is safe to perform this procedure. If
the Power icon is visible (either blinking or on
continu-ously), do not perform this procedure.
See “System States” earlier in this chapter for
details on modes represented by the Power
icon.
1. Ensure that the battery in your Tablet PC is
sufficiently charged, or connect an external
power source such as the AC adapter to
your Tablet PC.
2. Press the Power On/Suspend/Resume
button to start the system.
After performing initialization, the system starts
the operating system installed on the hard disk
drive. Once the operating system is running,
you can use the system.
SHUTTING DOWN THE SYSTEM
Follow these steps to shut down and turn off
your system:
1. If system operation has been suspended,
resume system operation. See “Resuming
System Operation” later in this chapter for
details.
2. Save your work and close all running
programs.
3. Choose Shut Down from the Windows Start
menu.
4. Carry out the Shut Down command.
The system is now in the Off state.
Icon Apperance
Power icon
displayed
continuously
Power icon
blinking
Power icon not
displayed
To Change State*
To enter the Off state, shut down the system using the
Start menu on your system.
To enter Suspend-to-RAM or Hibernate (Save-to-Disk) ❖
state, suspend system operation using either a hardware
or software suspend.
To enter the On state, resume system operation by
pressing the Suspend/Resume button.
To enter the Off state, resume system by pressing the
Suspend/Resume button, then shut down your system.
To enter the On state, start your system, or resume
system operation by pressing the Suspend/Resume
button.
Current State
On State
or
Idle State
Suspend-to-
RAM❖
Off State, or,
Hibernate
(Save-to-Disk❖)
Table 2-1 Changing System States
Ocampa2 (25-38) 10/12/03, 11:38 AM28

Fujitsu Stylistic Specifications

General

Brand	Fujitsu
Model	Stylistic
Category	Tablet
Language	English