6. MAINTENANCE, TROUBLESHOOTING
6-9
6.9 How to Remove and Re-install the Display Unit
During the off-season, or if your ship is not used for a lengthy period of time, you can
remove the display unit for security.
6.9.1 How to remove the display unit
1. Disconnect all cables connected to the display unit.
2. Cover the connector ends with vinyl tape to prevent foreign objects entering the
connectors. Also, cover the tape cable ends with a plastic bag, sealed at the cable
with vinyl tape, to prevent water intrusion.
3. Unfasten the knobs on the display unit (one per side).
4. Remove the display unit from the hanger.
6.9.2 How to re-install the display unit
1. Place the display unit in the hanger. Make sure that the display unit is facing in the
correct direction.
2. Fasten the knobs to the hanger (one per side).
3. Uncover the cable connector ends. Check that each connector is clean and has
no foreign objects inside.
4. Connect all required cables to the display unit.
5. Fasten all cables firmly.
Knob
(2 pcs)
Hanger
Control unit
To Next Page
Loading...
Need help?
General
