4.2 ID Setting
4-6
4.2.3 Setting Remote Handset ID
Transceiver unit can be connected to a maximum 4 Handsets (RB-8800/HS-8800 and/or
RB-8810/HS-8800). A parallel connection is made with the data line between
Transceiver unit and Remote Handsets. Communication between each Remote Handset
and Transceiver unit is carried out on the basis of ID number set up for each Remote
Handset. When more than one handset is connected, set up each Remote Handset with
different ID. If the same ID number is in use with different Handset, the system does not
function properly.
Procedure
1. Turn on the power of Transceiver unit while pressing Remote Handset’s [Menu] key.
Other way,
Unplug Remote Handset from RB-8800/8810 and then plug it back in.
2. Indicated information in the box below will be displayed on the handset monitor,
which brings you to handset ID setup mode.
Version No.
0550216-01.0x
Now ID=1
Input
New ID (1–4) =
3. Enter numerical ID that you like to set up and press inputted ID numbers will go into
“Now ID” in the bottom of the handset monitor above
4. Turn off the power.
5. Take the same procedures from 1 through 4 to set up the ID numbers for other
Remote Handsets.
To Next Page
Loading...
Need help?
General
