3. HOW TO MANAGE CHARTS
3-10
2. Click the [C-MAP] tab to the show the [Licenses] dialog box for C-MAP.
3. Click the [C-MAP Setup] button.
4. You are asked if you are sure to continue; click the [OK] button to continue and
register the eToken.
Note 1: "C-MAP: No connection to eToken" disappears from the Permanent warning
box after completion of the registration.
Note 2: You can show your C-
MAP system ID by clicking the
[C-MAP SystemID] button on the
[Licenses] dialog box for C-MAP.
3.6.2 How to install the C-MAP database and licenses
When you install the C-MAP database from a medium, all data is saved to the SSD.
Note 1: To share C-MAP charts between several ECDIS units, group the units before you
install the C-MAP charts. If the grouping is not done before chart installation, the charts
are not shared. In this case, remove the C- MAP charts, group the ECDIS units, then re-
install the C-MAP charts.
Note 2: The installation of a chart cannot be cancelled while it is in progress. If you get
an error message, try to install the charts again.
Note 3: Disable the Chart Alert function at the [Look-ahead] page of the [NAV Tools]
box (see section 8.2) before removing any C-MAP charts.
Note 4: The C-MAP database in the units selected for synchronization are synchro-
nized upon the successful completion of the database installation.
How to install the C-MAP database
1. Insert the medium that contains the C-MAP database.
2. Get into the Chart maintenance mode then click the [AUTO Import] button on the
InstantAccess bar
™
.
The [Install chart data] window appears and shows the percentage of completion,
with digital and analog indication.
C-MAP system ID
appears here.
To Next Page
Loading...
Need help?
General
