Furuno FR-8122 User Manual

1. OPERATIONAL OVERVIEW
1-53
1.42 Customizing (Initial Menu)
The Initial sub menu in the System menu contains items which allow you to customize your radar
to meet your operational needs.
1.42.1 Opening the Initial menu
1. Press the MENU key to open the menu.
2. Roll the trackball to choose System followed by Initial and press the ENTER key.
Initial menu
1.42.2 Description of Initial sub menu
Key Beep: A beep sounds when a key are pressed. You may turn this beep on or off.
Range Unit: Range may be shown in nm, km or sm.
Alarm Level: The target alarm may be set to sound against weak, medium or strong echoes.
Shift Speed: Set the ship’s speed to use calculate amount of display shift. The setting range is 1-
99 (kts).
STBY Mode Display: Set the function of the radar in standby.
Normal: Display “STBY” at the screen center.
Nav: Display navigation data.
Economy: Extinguish the backlight of the LCD. The radar must be switched from TX to ST-BY
to activate this mode.
Bearing Source: Choose the type of bearing sensor connected to the radar; True (gyrocompass,
satellite compass) or Magnetic (magnetic compass).
[ENTER]: Enter [CANCEL/HL OFF]: Back
[MENU]: Exit
GPS
Mark
Target Trails
Custom 1
Custom 2
Custom 3
Target
ARP
AIS
Tuning
Menu
Initial
System
Initial
Factory
Key Beep : On
Range Unit : nm
Alarm Level : Med
Shift Speed : 15 kt
STBY Mode Display : Normal
Bearing Source : True
Range Preset
Ship Speed Unit : kt
Depth Unit : ft
Temperature Unit :
°
F
Wind Direction : Apparent
Wind Speed Unit : kt
Port1 : Auto
GPS Buoy
Installation

Furuno FR-8122 Specifications

General

Brand	Furuno
Model	FR-8122
Category	Marine Radar
Language	English