3. ARP OPERATION
3-4
4. Choose On to enable automatic acquisition.
5. Press the ENTER key.
6. Press the MENU key to close the menu.
3.5 Terminating Tracking of ARP Targets
When ten targets have been acquired, no more acquisition occurs unless targets are cancelled. If
you need to acquire additional targets, you must first cancel one or more individual targets, or all
targets, using one of the procedures below.
3.5.1 Terminating tracking of selected targets
1. Place the cursor on the target to terminate tracking.
2. Press the CANCEL/HL OFF key to terminate tracking and erase the ARP symbol. A few
beeps sound and the symbol is erased from the display.
3.5.2 Terminating tracking of all targets
1. Press the MENU key to open the menu.
2. Choose ARP and press the ENTER key.
3. Choose All Cancel and press the ENTER key. The prompt shown below appears.
4. Choose Yes and press the ENTER key to terminate tracking on all ARP targets.
5. Press the MENU key to close the menu.
Are you sure?
Yes
No
To Next Page
Loading...
Need help?
General
