EasyManuals Logo

Furuno LS-6100 User Manual

Furuno LS-6100
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
24
4. The ROM, RAM and NMEA port are
checked, with the results shown as OK
or NG (No Good). For any NG, request
service. (A special connector is required
to test the NMEA port. Nothing appears
if no connector is connected.)
5. The squares at the right side of the test
display are for checking the controls.
Press each key and the arrows on the
Cursor Pad one by one. A control’s
corresponding on-screen square “lights”
in black if the control is normal.
6. To return to the Installation menu, press
the [MENU/ESC] key three times.
7. To restore normal operation, turn off the
power and turn it on again.
3.8 Test Pattern
This feature tests for proper display of
tones.
1. Turn on the power while pressing the
[MENU/ESC] key. Continue pressing the
[MENU/ESC] key until the Installation
menu appears.
2. Press to choose LCD PATTERN.
3. Press to start the test. The entire
screen is black.
4. Press again and the screen turns
white.
5. Press again and the screen shows a
four-toned display.
6. Press again to return to the
Installation menu.
7. To restore normal operation, turn off the
power and then it on again.
WHITE FOUR-TONE
BLACK
Test patterns

Other manuals for Furuno LS-6100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Furuno LS-6100 and is the answer not in the manual?

Furuno LS-6100 Specifications

General IconGeneral
BrandFuruno
ModelLS-6100
CategoryMarine Equipment
LanguageEnglish

Related product manuals