5. RC1815/RC1825 Equipment Setup
5-4
5.3 Felcom 15
Refer to the Installation Manual, Felcom 15
5.3.1 General
1) Insert a good, formatted, floppy disk into the Terminal.
2) Power up the Felcom 15, the status screen should show OK indications
and the GPS should indicate 3D.
5.3.2 IMN Input
(Refer to Pg. 19 of the Installation Manual, Felcom 15)
1) Press the [F8] key, using the down arrow key, highlight IMN and then
press the [Enter] key.
2) Type in the IMN and press the [Enter] key.
3) Press the [Esc] key. The screen will now prompt Update.
Select Yes and press the [Enter] key.
4) Press the [Esc] key until you return to the status screen.
5.3.3 External Equipment
(Refer to Pg. 20 of the Installation Manual, Felcom 15)
The Felcom 15 has been programmed for use with the following remote boxes:
1) IC-305 Distress Alert Unit
2) IC-306 Alarm Unit
Unless a DMC-5 or additional boxes are added no changes are necessary.
To change these settings, refer to Pg. 4 of the Dealers Manual.
To Next Page
Loading...
Need help?
General