7. RC1840 Equipment Setup
7-9
7.7 FS-5000
Refer to the Operator’s/Installation Manual, FS-5000
7.7.1 General
1) Power up the Transceiver and Control Head.
2) Start the self-test by pressing the [RCL] key, enter 9900 and then press
the [ENT] key. This test should show OK. If an error code appears, record it.
(Refer to Pg. 2-3 in the Installation Manual)
7.7.2 GMDSS Settings
1) After all self-tests are OK, change the following settings to meet
GMDSS requirements:
a) Power reduction on both 2182 and 2187.5 is disabled.
[STO] 9927 [ENT] 1 [ENT]
b) Minimum output power is 60W or more.
[STO] 9928 [ENT] 1 [ENT]
c) Enable BK RELAY. This is not enabled when a separate receive antenna is used.
[STO] 9982 [ENT] 1 [ENT]
d) TX delay time.
[STO] 9913 [ENT] 10 [ENT]
e) Enable dummy load (default setting).
[STO] 9981 [ENT] 1 [ENT]
7.7.3 RT Operation
1) On each band, verify that the antenna automatically tunes when the
[TX TUNE] key is pressed.
2) If all tests are OK, proceed on to the next section. If the tune fails, verify the
antenna, grounding system and coupler connections.
To Next Page
Loading...
Need help?
General