EasyManuals Logo
Home>FUTABA>Remote Control>10CAP

FUTABA 10CAP User Manual

FUTABA 10CAP
119 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
45
TIMER
submenu (stopwatch functions): controls three electronic clocks used to keep track of time remaining in a
FRPSHWLWLRQWLPHDOORZHGÀ\LQJWLPHRQDWDQNRIIXHODPRXQWRIWLPHRQDEDWWHU\HWF
Adjustability:
Count down timer: starts from the chosen time, displays time remaining. If the time is exceeded, it continues to count
below 0.
Count up timer: starts at 0 and displays the elapsed time up to 99 minutes 59 seconds.
Count down timer (Stop type): starts from the chosen time, displays time remaining, and stops at 0.
Model timer: cumulates ON time up to 99 hours 59 minites each model. Once Model timer function is turned off, the
cumulate time will also be reset to "0:00".
Independent to each model, and automatically updates with model change.
In either
TIMER
mode, the timer beeps once each minute. During the last twenty seconds, there's a beep each two seconds.
'XULQJWKHODVWWHQVHFRQGVWKHUHVDEHHSHDFKVHFRQG$ORQJWRQHLVHPLWWHGZKHQWKHWLPHVHOHFWHGLVUHDFKHG83
DOWN
TIMER
)
To Reset, choose the desired timer with the
CURSOR
lever (while at the startup screen), then press and hold DIAL for 1
second.
Activation by either direction of
SWITCH A-H, by THROTTLE STICK (
STK-THR
) (Using the THROTTLE STICK is
convenient if you are keeping track of fuel remaining, or for an electric, how much battery is left), by LOGIC SWITCH
Lsw1-Lsw3 or by the power SWITCH (
PWR SW
). Set up
LOGIC SW
: See p. 38.
Also the reset switch can be assigned (
SWITCH A-H or LOGIC SWITCH Lsw1-Lsw3)
GOAL of EXAMPLE: STEPS: INPUTS:
6HWWLPHUWRFRXQWGRZQPLQXWHV
being controlled by THROTTLE
STICK position. This is utilized to keep
track of actual Throttle on time to better
FRUUHODWHZLWKIXHOEDWWHU\XVDJH
Open
BASIC
menu, then open
TIMER
function.
for 1 second.
(If
ADVANCE
, again.)
to page 2.
C
to
TIMER
.
Go to
TIMER<2>
.
C
to
10
(TIMER<2>).
Adjust time to 4 min. 30 sec., count
down.
to
4
.
C
to
00
(TIMER<2>).
to 30.
Assign to THROTTLE STICK and set
trigger point.
C
to
ON>SwA
(TIMER<2>).
to
STK THR
.
C
to
50%
. for 1 second to
NULL
.
THROTTLE STICK to desired
SRVLWLRQ([VWLFN
for 1 second to set.
Close.
Where next? Adjust
END POINTs
DIWHU¿UVWÀLJKWWHVWVHHS
$GMXVWDX[LOLDU\FKDQQHODVVLJQPHQWVH[PRYHÀDSVWRDVZLWFKVHHS
Set up
TRAINER
functions: see p. 47.
TIMER<1>
TIMER<2>
TIMER<3>
(Home screen)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FUTABA 10CAP and is the answer not in the manual?

FUTABA 10CAP Specifications

General IconGeneral
BrandFUTABA
Model10CAP
CategoryRemote Control
LanguageEnglish

Related product manuals