nüvi 310/360/370 Owner’s Manual 55
appendIx
Mounting the nüvi on Your Dashboard
Use the enclosed mounting disk to mount your nüvi to the dashboard.
Important:
The permanent mounting adhesive is extremely difcult to remove after
it is installed.
To install the mounting disk:
Disk
Suction
cup mount
Suction
lever
1. Clean and dry the dashboard where you want
to place the disk.
2. Remove the backing from the permanent
mounting adhesive on the bottom of the
disk, and place the disk on the
dashboard.
3. Place the suction cup mount on top of the disk
4. Flip the suction lever down to secure the suction cup mount to the disk.
Removing the nüvi and the Mount
1. To remove the nüvi, press up on the tab on the bottom of the cradle.
2. Lift the nüvi off of the mount.
3. To remove the suction cup from the windshield, ip the lever toward you.
4. Pull the tab on the suction cup toward you.
Removing the Cradle from the Mount
To remove the cradle from the mount arm, turn the cradle to one side. The cradle
snaps off of the ball socket. To replace the cradle, snap the cradle on the ball socket.
To Next Page
Loading...
Need help?
General
