Quick-Start
13
Making Keypad Entries
Making a character entry to name a Personal Waypoint:
1. Press the MENU key to display the ‘Mark Personal Waypoint’ page.
2. Use the ROCKER keypad to highlight the waypoint name field and press ENTER. The first digit
of the waypoint name is highlighted.
3. Press the UP and DOWN areas of the ROCKER keypad to select the first character (right top
picture). Keep in mind that it may be fastest to use the DOWN key to go backwards through
letters and numbers to get the one you are looking for.
4. Press the RIGHT area of the keypad to move on to the next digit, or press the LEFT area of the
keypad to move back to the left and change a digit that you have already entered.
5. Repeat Steps 3 and 4 until the desired information is shown on the screen (bottom right
picture).
6. Press ENTER to accept the new name for the Personal Waypoint.
7. Use the ROCKER keypad to highlight OK and press ENTER to store the Personal Waypoint.
Named Waypoint
Marking a Personal Waypoint
Additional Information
If you wish to clear the entire entry, press the LEFT
area of the ROCKER
keypad while the first
character of the entry is highlighted.
To Next Page
Loading...
Need help?
General